top of page
⬅︎ Terug

Sturingen

Controller voor vliegende bewerkingen

MOTRONA


FS641: Controller for Machining "On the Fly"

The FS641 controller is used for control purposes in "flying material processing", but it is different to the FS340 in its larger design and even more extensive equipment. The cut-length specification can be set via a keyboard, but additionally - quickly and conveniently - via a front-mounted preselection switch. Furthermore this variant also has a programmable switching function with which, however, not only 4 fast transistor outputs (as with the FS340), but additionally 4 potential-free change-over contact output relays can be controlled. With its intelligent calculation algorithms, the FS641 controller offers the highest processing performance and precision with a short lag regulation. In contrast to the FS340 it is delivered in a larger installation housing for panel panels with 96 x 96 x 140 millimeters (3.78 x 3.78 x 5.51").

  • 2 impulsingangen met formaat A, B, 90° [HTL] of A, /A, B, /B [RS422]

  • 4 stuuringangen voor HTL/PNP/NPN/Namur-signalen [10 ... 30 VDC]

  • Ingangsfrequentie tot 300 kHz

  • 4 snelle transistoruitgangen, push-pull, kortsluitvast [5 … 30 VDC]

  • 4 potentiaalvrije wisselrelaisuitgangen

  • 1 schaalbare 14-bits analoge uitgang (±10 V of 0/4 … 20 mA)

  • Specificatie van de snijlengte via toetsenbord of front BCD decadeschakelaar

  • Voeding 24 VAC en 17 … 40 VDC

  • Compacte normpaneelbehuizing (volgens EN 60715)

  • Montage op rail met behulp van SM600 steunbeugels (optie)

  • Instelling via toetsen of via pc via seriële RS232-interface

  • PROFIBUS-verbinding via motrona gateway PB251

Datasheet

FS641

bottom of page